Aluminum reflector for IR lamp

Sun, 12 Jul 2026 10:27:42 +0800

Stop Wasting Your Watts: A Better Way to Handle IR Heat

Let’s be honest: wasting power in a semiconductor fab is just throwing money away. Most people stick with standard aluminum reflectors, but here’s the problem—they aren’t great at catching the full spectrum of an IR lamp. A lot of that energy just bleeds right into the machine chassis. It’s a waste. That’s why we switched to gold-coated reflectors. We basically take that lost energy and bounce it right back onto the wafer where it actually belongs. Why gold? Aluminum is what everyone uses, but gold is just better when you’re dealing with infrared. By adding a precise gold layer, we stop the reflector from soaking up the heat. This means every single watt you pull from the power supply actually hits the target. You get way more heat density without having to crank up the amperage on your lamps. It’s efficient. Simple as that. It’s all about the curve Now, a flat piece of metal won’t do the trick. We spend a lot of time obsessing over the curvature of the reflector to make sure the IR beam is focused. If the geometry is off by even a hair, you’ll end up with cold spots or weird thermal gradients across your silicon. But when it’s dialed in? You hit your target temperature faster, which means your cycle times drop. The “Catch” Nothing is perfect. Gold is amazing for efficiency, but it’s soft. Way softer than anodized aluminum. **Please, for the love of your equipment, do not scrub these with abrasive pads.**If you do, you’ll strip the coating and your reflectivity will tank. Stick to a non-contact cleaning routine. Also, keep in mind that since you’re concentrating more heat on the wafer, you need to double-check your cooling zones. You don’t want to overshoot your temperature setpoint because you’re suddenly pushing way more energy than you used to. Getting it running The best part? These are drop-in replacements. You don’t have to rewire your whole system or spend a weekend tearing things apart. Just swap out the housing, calibrate your pyrometers to handle the extra heat, and you’re good to go.

Aluminum on Master Infrared Heating Systems

Aluminum reflector for IR lamp

Stop Wasting Your Watts: A Better Way to Handle IR Heat